However if you have a ¼ inch of veneer with you then you can easily refinish it. Once we got the first layer off we moved to 150 grit.
Get a 220 grit sand paper and sand the whole top by hand to get a very smooth finish.
How to refinish wood veneer table. Then follow up with a good wipe-down with mineral spirits or TSP trisodium phosphate. Then apply contact cement to both surfaces or spread carpenters glue on the base wood. If the surface looks good and uniform in color you can apply a coat of dewaxed shellac as a base coat.
There is actually a slight groove in the table in one spot bc the stain was so deep. The sander will leave small almost undetectable marks in the raw wood. Then sand the surface with ultra-fine sandpaper and wipe off any swarf that results.
Since it is a thin veneer it went faster than you might think. Step 1 Before refinishing the veneer it is really important to assess the damage present on it. Set the broken veneer carefully into place matching the edges exactly and press firmly to knit the broken edges together.
Wood veneer is a thin layer of real wood. We began by using 90 grit sandpaper. Clamp the mended area.
First clean the surface with soap and water drying it off completely. Wipe stain onto the tabletop and around the edge keeping with the direction of the wood grain. We then VERY CAREFULLY used a scraper to scrap off the finish.
You can refinish veneer almost the same as you would refinish a piece of solid wood as long as you take precautions to avoid damaging the thin veneer. Wipe it clean with a tack cloth. Work in the stain to penetrate the wood pores.
Wipe the wood with a tack cloth and lightly sand again with 220-grit sandpaper to smooth the wood surface. Solid wood is a better candidate for refinishing than veneer which tends to be thinner. Wipe up the sanding dust with a tack cloth then apply a second coat.
Tip 1 Make sure it is wood veneer and not laminate. Laminate is not wood but rather plastic printed to look like wood. Air bubbles splits and corner lifts all follow the same basic steps for repairs.
Lightly brush the top coat onto the surface of the table and chairs. How To Remove the Old Finish We sanded the initial glossy coating off with a palm sander then applied a generous amount of paint remover and let it sit about 10-15 minutes. Wood veneer is very delicate.
Any and all the damage present should be repaired at this time. I do not recommend refinishing anything unless you have one of these puppies. Then the hubby went to town and sanded out the stains by hand.
Once you are done with the sander and the majority of the previous finish is gone wipe off the dust. Not every wood veneer furniture can be refinished. Sand the veneered furniture with 120-grit sandpaper just enough to rough up the wood surface.
It goes on white but dries clear quickly. A painstaking procedure the repair of any damaged veneer is essential to proper refinishing of the wood veneer furniture. Set up your tabletop refinishing project in an area with good ventilation as the compounds used in the process may contain harmful vapors.
If you dont know whether a surface is laminate or wood try sanding a small patch. And for that matter dont attempt to refinish laminate eitherits plastic people. You have to go with the grain of the wood and be really really careful to not make any gouges in the wood.
Allow the finish to dry for a few hours then lightly sand with a fine grit sandpaper to remove any brush strokes. Take care not to remove too much material as veneer is not too thick. Remove excess stain with a clean rag still working.
Below well share with you a few tips for successfully refinishing furniture with wood veneer. For a bubble tape the area with a couple of layers of masking tape and slice the bubble with a craft knife with a 10 blade.