Even when you are careful with the surface of a piece of wood veneer furniture accidents do happen. After several years of spilled drinks and dust particles the shine will diminish from the wood veneers finish.
How to glue and clamp a veneer bubble on wood furniture.
How to fix wood veneer table. The glue used in securing it to the substrate can also deteriorate leading to further failures. Before trying to repair a blister in other ways try this heat method. Everyday use can result in light scratches if you are not exceptionally careful to lift rather than slide objects across the surface of a table.
Bubbles and blisters in veneer on a flat surface such as a table can sometimes be repaired with a damp white cloth and a hot iron as long as the original glue used is a hide-type glue that reactivates when heated. Veneer is not however without drawbacks. A painstaking procedure the repair of any damaged veneer is essential to proper refinishing of the wood veneer furniture.
You can also use a knife if they need to be cut away. Weve calculated that in restoration veneer problems account for the most frequent repair work after loose chair joints. This is typical damage for wood veneer.
Apply wood oil directly to the veneer to prevent new bubbles from forming. Re-finish the damaged area or if necessary the entire surface or piece of furniture. 2 Cut out the patches of veneer that are blistered and fill in with wood filler or Bondo.
Use a C-clamp to clamp the veneer down between flat pieces of wood. Leave the clamps for a day or two. Apply some glue and put it back in place it should locate itself into place and clamp up using some scrap wood between the wood and clamp faces to keep the splintered piece flush with all planes of the leg and to ensure the clamps cant damage the wood.
Blistered veneer can be repaired 3 ways Veronica. Let the repair dry for one to two days. Use an additional clamp every 6 inches on the wood to firmly hold down the veneer.
Remove the clamps and rub off the excess dried glue from the edges using a damp shop cloth. Clamp or put a weighted object on top to keep the veneer in place. For a bubble tape the area with a couple of layers of masking tape and slice the bubble with a craft knife with a 10 blade.
Sand the edges of the damaged area with sandpaper to smooth out any roughness. With age humidity and mistreatment wood veneer will crack chip and blister. 3 Slice the blisters with the grain and use a syringe to inject wood glue.
Air bubbles splits and corner lifts all follow the same basic steps for repairs. Publications International Ltd. Leave the repaired area for one to two days and then lightly sand the edges and the surrounding surface.
Or if your piece is not properly protected during a move deeper scratches can scar the surface. Make sure you check out the bottom of the piece where there can be bubbling edges from water damage. The basic repair techniques mentioned in this article will help you keep the veneer on your wooden furniture looking like new.
The final product mimics real wood and creates a durable shiny finish. 1 Remove all the veneer and then stain andor paint top. Veneer is a thin plastic coating applied to particle board plywood or fiberboard to create aesthetically pleasing furniture including tables.
Rub the wood oil into the veneer with a cloth until the table is completely restored to its original condition. Then very lightly sand the patch and the surrounding veneer. Using a putty knife you can just pry away the loose bits.
Then put glue on the fitted patch and fix it into place. Step 2 – Repair Damaged Areas. DIY tutorials and techniques from the Furniture Refinishing StudioCheck out our NEW UPDATED VENEER.