Refinishing is an easy low-cost way to bring out natural beauty in wood furniture and make fine details shine. Sand the table beginning with the coarsest-grit sandpaper 100 grit and sanding in the direction of the wood grain.
When youre done stripping the table sand the surface in the direction of the grain to even out any discoloration or irregularities.
How refinish a wood table. To refinish a wood table start by coating the table in stripper waiting 15-20 minutes and using a plastic scraper to take the paint or varnish off. Sanding and Refinishing Wood Furniture 1 Remove all dirt grime and grease with a rag and all-purpose cleaner. Clear Varnish a small can of General Finishes water-based polyacrylic.
Let the stripper do its workgenerally 15 to 20 minutes for the solvent to loosen the finish. Use a paint brush to apply an even coat to the wood surface. Move the table to a ventilated area like a covered porch or garage where you can work without worrying about the mess.
Start sanding the table top using 120-grit sand paper. But staining isnt possible since theres no real wood to soak up the stain. Washing Wipe the table clean and dry it.
Apply Rubio Monocoat to Epoxy River TableTo apply rubio monocoat oil plus 2c finish to an epoxy river table simply mix 3 parts oil to 1 part activatorThis stuff goes a long way and its very easy to applyTo determine the coverage area for rubio monocoat use 1 ounce per 10 square feet. Apply it with a paintbrush. Think of cheap IKEA furniture although many of their tables are actually solid wood You can paint laminate furniture although you need to prep it with bonding primer first.
Furniture oils sink in and protect wood beyond the surface can be reapplied in the future and bring out rich colors in the wood without shine Try teak oil for denser woods or tung or Danish. Clean the Piece The most fundamental step of any furniture refinishing or renewing project is to give the piece in question a good and thorough clean. Sandpaper 10 sheets of 150 grit 3 sheets of 220 grit 1-2 sheets of 320 grit.
Then apply the new finish by applying a coat of stain. Depending on the desired color depth and richness apply more coats. After clear coating let your finished piece fully cure in a warm dry well-ventilated area for 24 hours before use.
How To Refinish a Wood Table. Sanding The first step is to lightly sand the table until it is smooth. Youll find wood conditioner at any paint supply store because its a common thing to use when you refinish furniture.
Lightly sand with 220-grit paper a very fine steel wool works too and clean with a tack cloth between coats. A single coat does the job and once it dries youre ready to stain. I actually ended up sanding the most damaged areas a second time on day two.
Place the table in a well-ventilated area such as an open garage or outdoors. A Paint Brush a 3-inch wide synthetic brush from Home Depot. Apply at least two coats of stain.
Below are six essential steps that address how to refinish wood furniture and how to strip finished wood. Apply the stain with a brush or a rag and use a separate rag to wipe off excess before it dries. Your options for staining are limitless.
There are two ways to refinish a table. You need to thoroughly clean off the piece of furniture you want to refinish or you will just end up grinding the dirt into the wood when you sand. Staining the wood causes the wood fibers to swell as they soak up the stain.
Make sure to move in the direction of the wood grain or the sandpaper will make small scratch marks that will only be visible when the new stain is applied. Notes on Alternative Refinishing Methods Brush Types Finish Types etc. Two Methods for Refinishing a Table.